About Ram-Pro 3 Piece Offset O2 Sensor remover & installer Socket Set.

Is your “Check Engine Light” on? It may be a bad O2 Sensor & you have to change it right away.

Want to Change it? O2 sensors are usually a pain to remove after about 100k+ miles of heat, & having them under the hood for some applications make them difficult to reach in tight spots.

BUT With this 3 Pc Upstream socket set you’ll be able to remove & install hex vacuum switches & O2 sensors on almost every vehicle easily.

Designed with mechanics in mind, this socket set works quickly & efficiently in the tight space around an O2 sensor to remove or install fast.

On the Vacuum Socket a side cutout allows you to easily slip the socket onto the sensor, preventing damage to wires.

Three configurations fit many applications (7/8″ or 22 mm sensors).

Includes:

(1) 3/8″ Drive x 7/8″ Vacuum Switch Socket, (2) 3/8″ Drive x 7/8″ O2 Sensor Sockets.

Constructed of vanadium & molybdenum steel for strength & durability & a black oxide finish.

The hardest part of changing an O2 sensor is removing the old sensor, but with this Ram-Pro tool the sensor will get out easily.

The long socket can be used to remove the sensor & the short for tightening.

TIPS: Use penetrating oil at least 24 hours prior to removal to make the job easier & more efficient.

When using the shorter wrench socket make sure you have a firm grip & it turns so you won’t strip the sensor.

Benefits:

Removes even rusted sensors
Great tight fit
Outstanding Performance
Convenient Storage
Includes Instructions
Comes in a nice case to keep the 3 sockets together
Super tool to have if you do your own auto work
Saves hundreds of dollars by doing the change yourself
Socket selection will make sensor removals painless
You may not need it for some time, but when you do, this is really handy
A must have for DIY mechanics

Product Features

• The Ram-Pro Low Profile Upstream deep socket set removes and installs oxygen sensors on most vehicles that are 7/8″/22mm in size
• YOU GET: 1 3/8″ Drive 7/8″x80mm (L) Vacuum Switch Socket – 2 3/8″ & 1/2″ drive, 30 & 50mm (L), ‘Crows Foot’ type Oxygen Sensor Sockets – Comes in a molded case With Instructions for protection and easy transport
• MATERIAL: Constructed of high performance (CR-V & CR-MO) vanadium and chrome molybdenum solid cast steel for strength and durability – Finished with Black Oxide to prevent rust
• DESIGN: Features a 6-point beveled nose design to grip sensor fasteners securely, preventing damage to the sensor, and a wire gate that slips the socket onto the sensor easily, preventing damage to the wires
• USE: Built for use with ratchets and breakers bars to remove and install oxygen sensors and hex vacuum switches on vehicles